Petroleum and natural gas industries. Aluminium alloy drill pipe thread connection gauging1 Scope This International Standard specifies the technical delivery condition, manufacturing process, material requirements, configuration and dimensions, and verification and inspection procedures for aluminium alloy drill pipes manufactured in accordance with ISO 15546. This International Standard also specifies the gauging procedure for taper buttress thread (right and left) and adjoining tapered stabilizing shoulders (bores) made of aluminium

such as landing gear

NOTE To align with the design standard EN 1992‑1‑1

ISO 30500 does not attempt to exhaustively address sustainability concerns with respect to non-sewered sanitation systems (NSSS)

personnel locks

the careful planning of sampling and the entire measurement strategy are of particular significance since the result of the measurement may have far-reaching consequences

Information on these aspects is given in BS 8110-1

in accordance with the specific International Standard describing the measurement of the property in question

BS EN 61131-7 gives a short introduction to the theory of fuzzy control and fuzzy logic as far as it is necessary for understanding fuzzy control programming

BS EN 16729-1 specifies the requirements for testing principles and systems in order to produce comparable results with regard to location

These coded designations will then be available for identification and marking purposes

Why should you use BS EN 3482-Steel X8CrNiTi18-10 (1

BS EN 15316-1:2017 includes some technical changes with respect to BS EN 15316-1:2007