International gear notation. Symbols for geometrical data1 Scope This International Standard specifies geometrical symbols for use in notation of gear data. It comprises two lists: the principal symbols, consisting of a single basic letter (see table 1); and subscripts to be used as necessary to qualify principal symbols (see tables 2, 3 and 4).

BS 6347-8 specifies test procedures for engine air cleaners fitted to agricultural tractors which are additional to those specified in ISO 5011

6 Health and safety of operators

Annex A specifies a unified method of test for compression value and stiffness of compression/ support hosiery using a Mark II HATRA Hosiery Pressure Tester

accidental contact with live electrical conductors at voltages up to approximately 100 V d

BS EN 50392 contains:

other than that specified as a routine requirement under the UK Water Supply (Water Quality) Regulations

Anticipating or identifying the environmental aspects of a product throughout its life cycle may be complex

BS EN 61176 states and defines the principal performance characteristics of circular saws that are of interest to the user and describe the standardized methods for measuring these characteristics

What is BS 4868 - Specification for aluminium sheets about

This part of BS 8486 sets out minimum requirements for the examination and testing of new lifts – including service

This International Standard describes the control of viewing conditions for magnetic particle and penetrant testing

— imaging in nuclear medicine