PEEKABOO OVAL DIE SET - Gina Marie DesignsTips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

Die cutting tricks and tips

Largest die cuts approx 5

Our $10 dies would have cost $10 to manufacture here so we made sure to pass the savings onto our customers

Largest measures 5

The inner lattice panel is VERY tiny and petite

Measurements

THE FULLEST DARKEST STAMP LAYER IS THE FIRST LAYER

5 inch wide

Pine needles are approx 3 inches long each

Approx 4x4 sized

Slightly decorative font

THIS DIE ONLY PIERCES THE DOTS IN THE SHAPE SHOWN