LoRaWAN I/O Controller LT-22222-L Relay Multi-InputLoRaWAN I O Controller LT 22222 L Relay Multi Input The LoRaWAN LT series I O Modules are Long Range LoRaWAN based I O Controller. It contains different I O Interfaces such as: analog current input, analog voltage input, relay output, digital input and digital output etc. The LT I O Modules are designed to simplify the installation of I O monitoring. The LT I O Controllers allow users to send data and reach extremely long ranges. It provides ultra

if you want to use SPI interface

Non-Invasive AC Current Sensor SCT013 100A

Using Flip&Click SAM3X with Python

Notes Pin Pin Notes NC 1 AN PWM 16 EN Module Enable Active-Low Hard Reset RST 2 RST INT 15 INT Device Interrupt output Chip select CS 3 CS TX 14 NC SPI Clock SCK 4 SCK RX 13 NC SPI Master Input Slave Output MISO 5 MISO SCL 12 NC SPI Master Output Slave Input MOSI 6 MOSI SDA 11 NC Power supply +3

1pcs Arducam 73mm 15pin to 22pin Ribbon FPC flat Wire Cable

While the PWM input is at the HIGH logic state

When the channel stays activated for longer than 10 seconds

Pollution click has high sensitivity to organic gases such as methanal (also known as formaldehyde)

MB7360 is the standard RS232 version of this sensor line

Flash: 8Mbit

APN/VPDN to ensure the security of data transmission

Accuracy    +/- 0