300 Watt Diversion Dump Load ResistorThis divert load resistor is for use to divert the excess power being generated when your wind turbine generator batteries are full and can be ran at 100% duty cycle due to the quality rib wound design. It can also be used with a solar array in diversion mode. The unit can be used alone to provide free heat as well by hooking your solar panels directly to it. For an alternative dump load see our DC water heating elements. The mounting "L" feet are

000+ cycles (@ 80% DOD)

With a low-consumption built in heater that automatically starts in cold temperatures

Easy to wire and install

Fully assembled by Missouri Wind and Solar with tried and true products

A 100-amp fuse and fuse block round out the kit

The Classic MPPT Charge Controller substantially increases the flexibility

Transfer Switch Specifications: 40 amp automatic transfer switch

Output Current: 40 amps

UL and CE approved

VW-1 Rated

These slip rings are ideal for our Freedom II PMGs and dual core PMAs

Charger Rate: 60A