Plastics piping systems for the trenchless replacement of underground pipeline networks - Replacement off the line by horizontal directional drilling and impact moling1 Scope This document specifies requirements and test methods for pipes and fittings which are part of plastics piping systems for the trenchless replacement of various underground pipeline networks, underground non pressure and pressure drainage and sewerage networks and underground water and gas supply networks, by means of horizontal directional drilling and impact moling. It is applicable to polyethylene (PE) pipes and fittings, as manufactured,

BS EN 3614 is a European standard on aerospace series which covers bolts

Hence the removal of the word “small” in the title and related references in PD IEC/TS 62257-1

Inward leakage

68 mg/100 g

BS 7659 specifies performance and marking requirements for lattice design cage enclosure dog muzzles for routine use

Controlgear: location

Roofing trade associations

puff duration

5 mm2 total cross-section because the conductor melts before the test is completed

d)      In Table 2:

BS 5766-7 on aflatoxin B1 in animal feeds applies to:

o Pivoted: horizontal and vertical (hung centrally or off-centre including reversible)