Shrink chuck 4,5° with cooling channels HSK 100 - 06 - 85Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- with clamping adapter Ø 6 mm und Ø 8 mm

Extension rod >6mm

For gauge-accurate working and controlling

For the coolant supply through the centre of HSK toolholders

Carbide tipped measuring faces

with adjustable ball spray nozzles

Quick change adaptors with safety clutch are supplied with a predefi ned torque

Protection level IP65

For mounting straight-shank tools and inclined flat according to DIN 1835 form E (Whistle Notch)

- Clamping positions: horizontal

which can cause high frictional forces on the thread flanks

For front surfacing and small diameters