Shrink chuck 4,5° HSK 63 - 05 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- with mode

Setting angle: 93°

Rolled thread

Clamping possible on both sides

Thread confi guration with a special design

tool steel

The chucking diameter is configured for a tool tolerance of h6

clamping depth

Hydraulic or manual clamping

- shock proof

With clamping screw and axial adjustment bolt

- With data output interface