Test code for machine tools - Determination of the noise emission1 Scope 1. 1 General This part of ISO 230 specifies methods for testing the noise of stationary floor mounted machine tools and related auxiliary equipment directly on the shop floor. The purpose of the measurements is to obtain noise emission data for machine tools. The data obtained may be used for the purpose of declaration and verification of airborne noise emission from machine tools as specified in ISO 4871, and also for the comparison of the

This document specifies a test method

Actions due to internal explosions

offer adequate fire-resistance and provide long service-life irrespective of external weather conditions

for the purpose of BS EN 60835-1-1 the elements comprising a digital microwave radio transmission system are those shown in BS EN 60835-1-1 for terrestrial radio-relay systems and satellite earth stations configurations differ

Range B: for FAME contents ranging from approx

BS IEC 60515 addresses the issues specific to neutron detectors used mainly for ex-core instrumentation systems

NOTE Only if their suitability has been established experimentally

BS 1336 provides characteristics requirements for knotting solutions during manufacturing

By offering adhesion after indentation test procedure guidelines

and European (CEN) cyanide methods for soils

raw material proportions

BS 5726:2005 gives recommendations and guidance on information to be supplied by the purchaser to the vendor and to the installer