Road vehicles. Elastomeric boots for drum-type, hydraulic brake wheel cylinders using a non-petroleum base hydraulic brake fluid (service temperature 100 °C max.)1 Scope This International Standard specifies performance tests for moulded rubber boots used at end closures on drum type wheel brake cylinders; these boots are designed to prevent the entrance of dirt and moisture which could cause corrosion and otherwise impair wheel brake operation. It is applicable to boots of both plain and reinforcement insert types, for fitting in wheel cylinders using a fluid in accordance with ISO 4925. It does not include

A general framework standard is given which imposes an hourly calculation for all cases which cannot be covered by simplified methods

What is BS EN 61988-3-1 - Mechanical interface of PDP about

BS EN 2959 provides you guidance on chemical composition

Common mating configuration for all variants are defined in IEC 60603-7

but it is not a management system standard

to data interfaces to the meter

which incorporates a displacement compressor of any type driven by an electric motor

BS ISO 16402 specifies the procedure for determining the fatigue behaviour of polymerized cement

or to a combination of these

1 Documentation

The function

It provides essential support for the developments required to meet key parts of the Government’s “Life Long Learning” agenda