DF724 - FLUSH JOINT INTERNAL JOINTER - 72x72mmSpare internal joint piece that enables the use of 72x72mm pipes that have been cut down. The joint piece is inserted into a plain ended pipe section and silicone sealed into position. Ideally 24hrs should be given before use to allow the silicone sealant to set. Fits inside plan ended pipe section for utilising pipe offcuts

but can be site bent to match specific roof pitches

formed from 6063 T6 hardened aluminium extrusion

Adjustable pipe clip For use with non eared Traditional aluminium downpipes (76mmØ)

Specialist screws that will not cause bi-metallic corrosion when used with our aluminium systems

Key installation requirements:

This is a short pipe length that can be used to extend the gutter outlets

Fits over gutter outlet spigot and into a plain ended pipe section

Traditional square aluminium downpipe shoe - 72x72mm

Site cut to suit

For use with deep fascia's

It is lightweight

Branches would require a pipe clip support to each joint